This command will copy data from an open file to another open file. Requirements: Two files must be open, one for reading, and the second for writing. e.g.
O 1 R /sourcefile.txt O 2 RW /destfile.txt
Copy File will copy from the current location in the source file, up to “num” bytes if specified, to the destination file (starting at the destination's current location).
You can interrupt the transfer at any time by sending
«ESC» (ASCII 27, HEX 0x1B).
B fh1 fh2 [num]
fh1/fh2is a file handle (1 - 4). Use the Free Handle command to get a free file handle.
numis the number of bytes to copy from
numis not given, or is greater than the size of
fh1, then the entire contents of
NULL | response | Enn
response depends on the
C setting shown below.
C = 0:
C = 1:
C = 2:
nn..nn bytes copied at r..rr bytes/second
C = 3:
#####...####nn..nn bytes copied at r..rr bytes/second
To copy 200 bytes from the current location of handle 1 to handle 2:
B 1 2 200
To copy the entire source file to the destination file:
O 1 R /sourcefile.txt O 2 RW /destfile.txt B 1 2
To copy 600 bytes from position 12000 of handle 1, to handle 3, starting at position 50000:
O 1 R /sourcefile.txt O 3 RW /destfile.txt J 1 12000 J 3 50000 B 1 3 600
To copy the entirety of handle 1 to the end of handle 2 (appended):
O 1 R /sourcefile.txt O 2 RW /destfile.txt J 2 E B 1 2
or (note that the destination file is opened for append)
O 1 R /sourcefile.txt O 2 A /destfile.txt B 1 2