Here is where you'll find information on the new firmware releases for the rMP3 Playback Module.

1. added: PC Y command to retrieve spectrum analyzer output (PC Y P for peaks, PC Y S to set bands).
2. added: IC T command to retrieve track length.
3. added: low power mode.
   • Cuts power consumption in half, when idle
   • Expect less than 5 mA
   • RTC still runs, keeping time
   • Mode is activated with setting “Z”
     • S Z 1 - sets into low power mode.
     • The setting remains active until cleared.
4. fixed: hang on boot (vs10xx init problem).
5. fixed: wildcard handling in listing commands.
6. fixed: 7 bit trigger repeats if held low.
7. fixed: playback speed change - 250% now acceptable, playback time updated.
8. fixed: temp settings not loaded from config file.

Rogue Code - rMP3 Beta Downloads - rMP3-100-02-b002

Use the Firmware Update Tool up update the firmware on the rMP3.

Demo of the spectrum analyzer output: