Min: 10
Voltage - 5v only required Current - 20mA Typ. Resolution - 0.1 Degree Accuracy - 3-4 degrees approx. after calibration Output 1 - Timing Pulse 1mS ... more info
This Dual H-bridge unit is based on the TI SN754410 chip and can provide up to 1.1A per side continuous and 2A peak. Includes heat sink, not pictured.
Voltage - 5v logic supply and 5v - 50v for the motor Current - 50mA Max for logic and up to 20A for the motor Control 1 - 0v - 2.5v - 5v Analogue for ... more info
FEATURES: 1 Amp 7805 Voltage Regulator MCU: Atmel ATmega644P (pico-power) 16 MHz Crystal Oscillator Total Flash Memory: 65536 bytes (64 KiB) ... more info
FEATURES: 5 Amp 1084 Voltage Regulator MCU: Atmel ATmega644P (pico-power) 16 MHz Crystal Oscillator Total Flash Memory: 65536 bytes (64 KiB) ... more info
FEATURES: Detection depth of 0.4" - recommended maximum. 2" x 2" size, 1.5" x 1.35" key area. -40C to +85C industrial temperature range. ... more info
If you wish to get the Arduino compatible headers as well, make sure you select "Include" at the bottom of this page. Arduino™ board compatible Easy ... more info
The rPower is an accessory board for the Rogue Robotics uMMC/uMP3/rMP3. It allows you to power those boards with a 7-12V external supply (wall ... more info
These sensor mounts are designed for use with the Rogue Blue robot bases. Mounts Devantech SRF04 or SRF08 Ultrasonic sensors or Sharp GP2D12/GP2D120 ... more info
FEATURES Powerful and easy serial interface to SD/SDHC/MMC/TF flash memory cards. MMC, SD (SDC), SDHC cards supported. microSD, transflash, and ... more info
Copyright © 2013 Rogue Robotics